Amx ViewStat Bedienungsanleitung PDF herunterladen (Seite 55)

Using the NetLinx Module to Program the ViewStat

ViewStat Communicating Thermostat

Command Interface - SEND_COMMANDs (Cont.)

Command Description

'T-<stat> HMODE?' Query for current humidify mode.

Parameter:

• <tstat> : id of thermostat/zone

Example:

'T-22 HMODE?'

'T-<tstat> HOLD-<val>' Set thermostat hold state.

Parameters:

• <tstat> : id of thermostat/zone

•<val>:

0 = take thermostat out of hold mode

1 = place thermostat in hold mode

T = toggle hold state

Example:

'T-2 HOLD-ON'

'T-<stat> HOLD?' Query for current hold state.

Parameter:

• <tstat> : id of thermostat/zone

Example:

'T-1 HOLD?'

'T-<tstat> HUMIDIFY-<val>' Set humidify set point.

Parameters:

• <tstat> : id of thermostat/zone

•<val>:

+ = Increase humidify set point by one percent

- = Decrease heat set point by one percent

10-90 = humidify point (in percent)

Example:

'T-6 HUMIDIFY-30'

'T-<stat> HUMIDIFY?' Query for current humidify set point.

Parameter:

• <tstat> : id of thermostat/zone

Example:

'T-1 HUMIDIFY?'

'T-<tstat> HUM?' Query for current inside humidity.

Parameter:

• <tstat> : id of thermostat/zone

Example:

'T-14 HUM?'

'T-<tstat> ID?' Get thermostat identification number.

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 67 68

Keine Kommentare

Amx ViewStat Bedienungsanleitung Seite 55