3613000 RESEARCH DRIVE, RICHARDSON, TX 75082 • 800.222.0193 • 469.624.7153 fax • TECHNICAL SUPPORT 800.932.6993
© January 2013 AMX. All rights reserved. AMX does not assume responsibility for any errors or omissions.
RECOMMENDED ACCESSORIES DESCRIPTION PART # PAGE #
IRX-PP38 Plasma Proof IR Sensor (FG460) 348
PSN6.5 6.5 Amp Power Supply (FG423-41) 415
PSN4.4 4.4 Amp Power Supply (FG423-45) 414
AC-RK Accessory Rack Kit (FG515) 410
AC-SMB Surface Mounting Bracket (FG525) 412
CC-232 RS232/422 Cables (FG10-752-04) 420
CC-NIRC IR Cables (FG10-000-11) 420
SPECIFICATIONS
DIMENSIONS (HWD)
• 1 9/16” x 5 9/16” x 5 1/8” (4.01 cm x 14.10 cm x 13 cm)
• RU: 1
WEIGHT
1.30 lbs (590 g)
POWER
• 300 mA @ 12 VDC
• Power requirements are usage dependent
ENCLOSURE
Metal with black matte finish
ONBOARD MASTER
304 MIPS
CERTIFICATIONS
FCC Part 15 Class B, CE, and IEC 60950
FRONT PANEL COMPONENTS
• Program Port
• Conguration DIP Switch: Sets the communication parameters for the
Program port
• IR RX LED: Red LED lights when IR data is being received via the rear
IR RX port
• IR LEDs: Three red LEDs light during the transmission of IR or Serial data via
the rear IR port
• I/O LEDs: Four yellow LEDs light when the rear I/O channels 1-4 are active.
LED indicator for each I/O port reects the state of that particular port
• Serial LEDs
• LINK/ACT: Green LED lights when the Ethernet cable is connected and an
active link is established. This LED also blinks when receiving Ethernet
data packets
• Status: Green LED lights when the Controller is programmed and
communicating properly
• Output: Red LED lights when the Controller transmits data, sets channels,
sends data strings, etc.
• Input: Yellow LED lights when the Controller receives data from button pushes,
strings, commands, channel levels, etc.
• ID Pushbutton: Sets the NetLinx ID (Device only) assignment for the device
REAR PANEL CONNECTORS
• RS-232/422/485 (Port 1)
• IR RX (Port 6)
• Digital I/O (Port 5)
• IR/Serial (Ports 2 - 4)
• AxLink LED
• AxLink Port: 4-pin 3.5 mm mini-Phoenix (male) connector provides data and
power to external control devices
• Ethernet Port: RJ-45 port for 10/100 Mbps communication. LEDs show
communication activity, connection status, speeds, and mode information:
- SPD (speed) - Yellow LED lights On when the connection speed is 100 Mbps
and turns Off when the speed is 10 Mbps.
- L/A (link/activity) - Green LED lights On when the Ethernet cables are
connected and terminated correctly, and blinks when receiving Ethernet
data packets.
• Power Port: 2-pin 3.5 mm mini-Phoenix (male) connector
ENVIRONMENTAL
• Operating Temperature: 0º C (32º F) to 50º C (122º F)
• Operating Humidity: 20% to 85% RH
• Heat Dissipation (Typical): 12.3 BTU/hr
INCLUDED ACCESSORIES
• 2-pin 3.5 mm mini-Phoenix female PWR connector (41-5025)
• 6-pin 3.5 mm mini-Phoenix female I/O connector (41-5063)
• Three CC-NIRC IR Emitters
• Two 4-pin 3.5 mm mini-Phoenix female connectors (41-5047)
nI-900 central controllers
(46 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern