AMX AXB-SPE Bedienerhandbuch

instruction manualAXlink Bus ControllersAXB-REL8Axcess Relay Controller

Connection and Wiring6AXB-REL8 Axcess Relay ControllerTesting the installation1. Check AXlink status LED - it should blink once per second (see Specif

Connection and Wiring7AXB-REL8 Axcess Relay ControllerSystem Worksheet and Installation Guide AXB-REL8Dealer ID#Dealer PO#Job SO#Description Se

AMX reserves the right to alter specifications without notice at any time.brussels • dallas • los angeles • mexico city • philadelphia • s

AMX Limited Warranty and DisclaimerAMX Corporation warrants its products to be free of defects in material and workmanship under normal use for three

Table of ContentsiAXB-REL8 Axcess Relay ControllerTable of ContentsProduct Information ...

iiAXB-REL8 Axcess Relay ControllerTable of Contents

Product Information1AXB-REL8 Axcess Relay ControllerProduct InformationThe AXB-REL8 Relay Controller provides remote control for up to eight relay fun

Product Information2AXB-REL8 Axcess Relay ControllerSpecifications (Cont.)Dimensions (HWD) 1.51" x 5.55" x 5.45" (3.84 cm x 14.10 cm x

Connection and Wiring3AXB-REL8 Axcess Relay ControllerConnection and WiringSetting the DEVICE Dip SwitchThe eight-position Device DIP switch is locate

Connection and Wiring4AXB-REL8 Axcess Relay ControllerPreparing captive wiresTo connect the wiring into a captive-wire connector:1. Strip 1/4 inch off

Connection and Wiring5AXB-REL8 Axcess Relay ControllerAXlink data and power connectionsConnect the control system's AXlink connector to the AXlin