AMX UPC20+ Spezifikationen PDF herunterladen (Seite 11)

Product Information

UPC20+ Universal Power Controller

Power Control mode

The tables below specify the DIP switch settings for momentary, latching, 2-button On/Off, and

(momentary or latching) operation of K1 and K2.

Remote Sensor Control mode

The UPC20+ can also be controlled via the serial output from an AMX IR sensor. Remote sensor mode

is selected by setting jumper JP1 to the "Remote" position (jumper on the left 2 pins), as shown in

FIG. 3. (The jumper must be in position when power is applied to the UPC20+).

When controlled by a remote sensor, the UPC20+ is in 2, 3-button timer motor control mode. When the

timing potentiometer R8 adjusted to zero ohms (no time delay), the remote sensor provides momentary

control.

A 3-bit code (radio code) set on DIP switch S2 associates an AMX handheld remote control with a

UPC20+. This allows up to 8 UPC20+ and IR sensors to be used in the same room without interfering

with one another. It is possible to control 2 separate UPC20+'s with one handheld remote control. The

4th switch of DIP switch S2 on the PCB selects between the two UPC20+'s. The table below lists the

results of the 16 possible DIP switch selections in remote sensor mode.

Power Control Mode DIP Switch Positions S2

1 2 3 4 Control Mode

On On On On Momentary On/Off

Off On On On Latching On/Off

On Off Off On Two-Button On, Off

On Off On On #1 Momentary, #2 Latching

Off Off On On #1 Latching, #2 Momentary

Control Input Wiring to P2 Terminals

4 5 6 7 8 Control Mode

Common #1 On/Off #2 On/Off N/A N/A Momentary, Latch On/Off

Common #1 On #2 On #1 Off #2 Off Two-Button On/Off

FIG. 3

JP1 mode settings

JP1

osure

mode

Remote sensor

mode

If motors of any kind are used, do not set to a Power Control mode. When a Power

Control mode is selected, both relays can be on at the same time. Motors can be

severely damaged if this happens.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 20 21

Keine Kommentare

AMX UPC20+ Spezifikationen Seite 11