AMX TPDESIGN4 V2.5 Bedienungsanleitung PDF herunterladen (Seite 5)

Revision 1.27, July 3, 2014

FEATURES NOT YET AVAILBLE IN G5

The following features are currently supported in the Modero X G4 Series Touch Panels and will be

supported by G5 in a future software update:

 Bluetooth

 Recovery Mode firmware update (ability to update firmware by inserting a USB drive into the

panel at boot time)

o Firmware update still supported via network and USB drive after panel has booted

 Dynamic reordering of sub-pages

OPTIMIZED COMMAND SET WITH CONSISTENT FORMATTING

If something needs to be done via a command, only one command is necessary. There is no need to

support multiple commands that do the same thing. Furthermore, the current G4 command set is

currently a mix of G4, G3 and even some G2 command formats. All commands supported in G5 will be

altered as necessary to adhere to the current G4 command format (utilizing the ^xxx or ?xxx formats),

with a few exceptions noted in this document. The following table lists which commands should be used

and which commands have gone away in the initial release of G5 (i.e. LR), unless otherwise noted.

Please note that the ^BMF/@BMF command as well as the ^BMC command have been removed

completely and are not supported in G5 now, or in the future.

Please note that commands highlighted in yellow are new commands for G5 and are not implemented

in any current or future G4 product.

Related Feature

Use This

Instead Of

All Features

Anything listed below

^BMF (all parameters),

@BMF (all parameters),

^BMC (all parameters)

Audio Control

?VOL and Custom Event 1306,

^VOL, ?MUT and Custom Event

1305, ^MUT

?MCO and Custom Event 1314

Bargraph Control

^GLL, ^GLH

^BMF…%GL, @BMF…%GL,

^BMF…%GH, @BMF…%GH

Bitmap Assignment

?BMP and Custom Event 1002,

@BMP, ^BMF…%P, @BMF…%P

1 2 3 4 5 6 7 8 9 10 ... 48 49

Keine Kommentare

AMX TPDESIGN4 V2.5 Bedienungsanleitung Seite 5