AMX RPMLoader Bedienungsanleitung PDF herunterladen (Seite 6)

What’s New in X-Series Controllers

New NetLinx Commands

RS232 FAULT COMMANDS: (PORTS 1-8)

IR TX FAULT COMMANDS: (PORTS 11-18)

PoE COMMANDS (PORT 24-27)

RS422/485 (Port 1, Port 5)

For the RS-232/422/485 ports a new parameter to the SET BAUD command is required to enable RS-422 mode. The

new commands to turn on 422/485 are:

When 422/485 are disabled, the port operates in 232 mode.

Note: To disable both 422 and 485 modes with one command, end the command with 422/485 Disable.

AxLink Power and Fault Commands

AxLink power can be shut off by command:

The device responds with:

AX FAULT: UPPER/LOWER

'SET FAULT DETECT ON' Enables fault detection on the port (default setting)

'SET FAULT DETECT OFF' Disables fault detection on the port

'CLEAR FAULT' Forces reset back to normal status

'GET FAULT' Responds with one of the following: 'DISABLED', 'NONE', or

'NO DEVICE'

'GET STATUS' Responds with either "STATUS: NORMAL" or "STATUS: FAULT"

'SET FAULT DETECT ON' Enables fault detection on the port (default setting)

'SET FAULT DETECT OFF' Disables fault detection on the port

'CLEAR FAULT' Forces reset back to normal status

'GET FAULT' Responds with one of the following: 'DISABLED', 'NONE', or

'NO DEVICE'

'GET STATUS' Responds with either "STATUS: NORMAL" or "STATUS: FAULT"

'SET FAULT DETECT ON' Enables fault detection on the port (default setting)

'SET FAULT DETECT OFF' Disables fault detection on the port

'GET FAULT' Responds with one of the following: 'DISABLED', 'NONE',

'UNDER-VOLTAGE / OVER-VOLTAGE', 'CURRENT OVERLOAD', 'LOAD

DISCONNECT', 'MAX POWER EXCEEDED', or 'POE NOT AVAILABLE'

'GET STATUS' Responds with either "STATUS: NORMAL" or "STATUS: FAULT"

'SET POWER ON' Enables PoE to the port (default)

'SET POWER OFF' Disables PoE to the port

'GET CLASS' Responds with either 'DISABLED', 'NO DEVICE', or 'CLASS x

DEVICE' (x=0 to 4)

'GET VOLTAGE' Responds with number in Volts (typically this is around 55

Volts)

'GET CURRENT' Responds with number in milliAmps

’SET BAUD <baud>,<parity>,<data>,<stop>,[422<ENABLE | DISABLE>]’

’SET BAUD <baud>,<parity>,<data>,<stop>,[485<ENABLE | DISABLE>]’

’TSET BAUD <baud>,<parity>,<data>,<stop>,[422<ENABLE | DISABLE>]’

’TSET BAUD <baud>,<parity>,<data>,<stop>,[485<ENABLE | DISABLE>]’

‘AXPWRON [LOWER/UPPER]’

‘AXPWROFF [LOWER/UPPER]’

‘GET AX FAULT’

1 2 3 4 5 6 7

Kommentare zu diesen Handbüchern

Keine Kommentare

AMX RPMLoader Bedienungsanleitung Seite 6

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Software AMX RPMLoader