AMX NXT-CV10 Spezifikationen PDF herunterladen (Seite 51)

Installation

10" Modero Touch Panels

Installing the NXD into drywall using Expansion Clips

Expansion clips are mounted through the three oval holes located along the rim of the NXD-CV10. As the

screw is tightened, the clip bends toward the insertion hole and into the wall. This bending creates a "grip" on

the wall by either pressing onto the wall or by securing the drywall between the housing and the drywall clip.

The most important thing to remember when mounting the NXD is that the outer frame (Mounting Tabs) must

be installed flush against the mounting surface.

Refer to SP-2259-03 for detailed installation dimensions (reproduced in FIG. 40).

It is recommended that you cutout the surface slightly smaller than what is outlined in the

installation drawings so that you can make any necessary cutout adjustments.

1. Prepare the area by removing any screws or nails from the drywall before beginning the cutout process.g.

2. Cut out the drywall surface for the NXD Wall Mount unit using the dimensions shown in FIG. 40. Be sure

to cut out the three notches along the sides to accommodate the three corresponding drywall expansion

clips (included).

3. Remove the Faceplate/bezel (A in FIG. 41) from the main NXD unit (B in FIG. 41) by gripping the

faceplate and pulling with gentle outward force.

4. Thread the incoming power, RJ-45, Ethernet, USB, and any optional audio/video wiring (from their

terminal locations) through the surface opening. Leave enough slack in the wiring to accommodate any

re-positioning of the panel.

5. Connect all data and power wiring connectors to their corresponding locations along the left side of the

(un-powered) NXD touch panel.

Verify that the terminal end of the power cable is not connected to a power source before plugging

in the 2-pin power connector.

FIG. 40 NXD-CV10 Wall Mount panel dimensions using expansion clips

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 207 208

Keine Kommentare

AMX NXT-CV10 Spezifikationen Seite 51