
3
(1) RJ-45, TCP/IP Port (ICS LAN 10/100)
LC Duplex conforming to ANSI TIA/EAI 604-10 (FOCIS
10A)
Transport Layer Throughput
6.8 dB (typical), 3.2 dB (stressed) between DXLink
Fiber Transceivers
Optical Modulation Amplitude (OMA): -4.3 dBm (min)
Optical Modulation Amplitude (OMA) Sensitivity: -11.1
dBm (typ), -7.5 dBm (stressed)
HDMI
DVI-D (single link with HDMI cable adapter)
DisplayPort ++ (Input Only, with HDMI or DVI cable
adapter)
Local Loopback Output Connector
(1) HDMI Type A Female Local Loopback Output, +5 V
DDC Pin Output 55 mA, non-scaling
Progressive Resolution Support
480p up to 1920x1200 @ 60 Hz (including but not
limited to those resolutions shown in the “Instruction
Manual – DXLink Fiber Transmitters and Receivers”
Interlaced Resolution Support
480i, 576i, 1080i (including but not
limited to those resolutions shown in the “Instruction
Manual – DXLink Fiber Transmitters and Receivers”
Note-Reminder: Interlace video supported into the
Transmitter, progressive only supported out of the
Receiver unless in non-scaling Bypass
Yes, if Scaler on corresponding output board or DXLink
Fiber RX is set to Bypass mode
Frame Packing 1080p 24Hz
Frame Packing 720p 50/60Hz
Frame Packing 1080i 50/60Hz
Top-Bottom 1080p 24Hz
Top-Bottom 720p 50/60Hz
Side-by-Side Half 1080i 50/60Hz
24-bit, 30-bit, 36-bit
30-bit and 36-bit supported when the HDMI DXLink
RX Scaler is in Bypass mode and format is 1080p60 or
less
RGB 4:4:4
YCbCr 4:4:4 and 4:2:2
(Input signal support for YCbCr 4:4:4 and 4:2:2, output
color-space is converted to RGB 4:4:4)
Kommentare zu diesen Handbüchern