AMX Mouse Betriebsanweisung PDF herunterladen (Seite 13)

Chapter 1: Product Overview 7

identifies the attached server within the system. The connection between the

AMX system and these modules is through industry standard UTP cabling.

UTP cables

The AMX system uses video technologies that compensate for the losses that

occur in all UTP cables. These technologies make the AMX compatible with

most UTP cable types and support AMX use in environments where there are

combinations of UTP cable types and patch panels. The AMX will function

correctly with any combination of CAT5, CAT5e and CAT6 cables.

NOTE: Throughout this manual, the generic term UTP refers to any CAT cable used by the

AMX system.

Safety Precautions

To avoid potential video and/or keyboard problems when using Avocent products:

• If the building has 3-phase AC power, ensure that the server and monitor

are on the same phase. For best results, they should be on the same circuit.

To avoid potentially fatal shock hazard and possible damage to equipment,

please observe the following precautions:

• Do not use a 2-wire extension cord in any Avocent product conﬁ guration.

• Test AC outlets at the server and monitor for proper polarity

and grounding.

• Use only with grounded outlets at both the server and monitor. When

using a backup Uninterruptible Power Supply (UPS), power the server, the

monitor and the AMX switch off the supply.

NOTE: The AC inlet is the main disconnect.

DC installation safety considerations

As a safety precaution, install this product in an area with limited or controlled

access. A readily accessible disconnect device that is suitably approved and

rated shall be incorporated in the field wiring. Connect field wiring from the 48

VDC power source to the screw terminals marked plus (+) and minus (-) on

the rear panel of the unit. Connect field wiring from earth ground to the screw

terminal marked with the ground symbol. Terminals will accommodate

wiring from 26 to 12 AWG (up to 2.5 mm

maximum cross section). Strip each

wire, insert it in the square opening in the terminal block and tighten the

screw above it to a maximum of 70 ounce-inches (0.5 Nm) using either a flat

or Phillips-head screwdriver.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 71 72

Keine Kommentare

AMX Mouse Betriebsanweisung Seite 13