Lighting Relay Panel
Controller User’s Guide
www.lumisys1.com
Due to continuous product improvement, Lumisys reserves the right to change product specications without notice.
Page 12
• To determine the address of the LRP Controller add the value of LEDs 2-9 that are blinking. All LEDs blinking will repre
sent address 255.
• To increment the address by one press the OVER (or CH) pushbutton.
Continue to increment until the desired network
address is displayed.
• To decrement the address by one press the STAT (or TG) pushbutton.
Continue to decrement until the desired network address is displayed.
• To save the network address to non-volatile memory, press the AUTO (or BK) pushbutton.
This will also return the LRP Controller to auto mode.
• Failure to Press the AUTO (or BK) pushbutton will result in loss of network address after power failure because it will
not be saved to non-volatile memory.
Wake-Up LEDs
• After 10 minutes of no pushbutton activity the LEDs will enter an LED saver mode much like a screen saver mode on a PC.
• To wake up the LEDs press the STAT (or TG) pushbutton. The LED’s will illuminate to display group and output status.
Resetting the LRP Controller
• The LRP Controller can be reset if you are experiencing abnormal behavior Resetting is the same as powering down
and powering back up the LRP Controller.
• This will load the data saved in its non-volatile EEPROM into its RAM.
• To reset the LRP Controller press the three pushbuttons OVER (or CH), AUTO (or BK) and STAT (or TG) simultaneously.
Pushbutton Mode Expiration
• Override, Stat and address-set modes (as well as LED illumination) will time-out in 10 minutes with no pushbutton
button activity.
• Mode expiration does not restore relays or save a new address until AUTO (or BK) is pressed. In the meantime how
ever, relays will respond to new serial commands and inputs.
• Each LRP Controller is network ready for RS-485 with 500 volt isolation circuitry.
• Up to 255 LRP Controllers can be networked over a twisted pair of wires.
• LUMISYS LRP Controllers provides seamless integration with the following Building Automation Systems (BAS):
• Alerton Technologies via LUMISYS BACNET or Modbus E-Link
• Andover Controls via programmable port in their controller
• Automated Logic via LUMISYS BACNET E-Link
• BACNET via LUMISYS E-Link
• Delta Controls via LUMISYS BACNET E-Link
• Honeywell via LUMISYS BACNET or Modbus E-Link
• Johnson Controls Metasys via Direct Connect
• MODBUS via LUMISYS Modbus E-Link
• Siemens Building Technologies via Open Processor with LUMISYS driver
• Teletrol Systems via programmable port in their controller
• Trane Company via LUMISYS BACNET E-Link
• Others available, ask your LUMISYS System Provider for details.
• Pressing the STAT (or TG) Pushbutton displays the serial status on the L28 Series. Network Communications status
is always displayed on the non-L28 Series controllers. See the “Group Output and System Status LEDs” section in this
user guide that denes the signicance of each STATUS LED.
LRP Controller Network Features
(48 Seiten)
(2 Seiten)
(2 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern