AMX AMX78 Installationshandbuch PDF herunterladen (Seite 10)

Hood/Trunk Pin Switch

1. Locate the vehicle hood and/or trunk pin switch that show ground when

the hood or trunk is open only.

2. Connect the alarm module to the vehicle hood and/or trunk pin switch wire.

3. If the vehicle does not have a hood or trunk pin switch, install an alarm

pin switch and connect it to the alarm module TAN wire.

Siren

1. Choose a location in the engine compartment away from high heat engine

components, moving parts and direct exposure to water.

2. Make sure the siren and siren wires cannot be seen or reached from below

the vehicle.

3. Mount the siren with the two self tapping screws to a solid metal surface.

4. Connect the siren BLACK wire to the alarm module VIOLET wire.

5. Connect the siren RED wire to the alarm module RED wire.

Power and Ground Connections

CAUTION : Do not plug in the system fuses until the final step

below.

1. Connect the alarm RED wire to one of the supplied fuse assemblies.

2. Connect the alarm RED/WHITE wire to the other fuse assembly (if the

vehicle parking lights are positive).

3. Connect the fuse assembly(s) to one of the supplied 10mm ring terminals.

4. Connect the alarm BLACK wire to the other 10mm ring terminal.

5. Remove the (+) and (-) battery bolts. Do not disconnect the battery clamps.

6. Connect the empty fuse assembly(s) to the positive battery post.

7. Connect the alarm BLACK wire to the battery negative post.

8. Inspect all alarm wiring. Make sure all wires are connected.

9. Install the 5 amp fuse in the alarm module RED wire fuse assembly.

10. Install the 20 amp fuse in the alarm module RED/WHITE fuse assembly (if

the vehicle parking lights are positive).

AMX78(3) Installation Manual - Revised 0799

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Keine Kommentare

AMX AMX78 Installationshandbuch Seite 10