AMX AMX78 Installationshandbuch PDF herunterladen (Seite 9)

Parking Lights

1. If the parking lights are positive trigger, connect the RED/WHITE wire to

the battery positive (+) terminal through the 20 amp fuse.

NOTE: Do not connect the RED/WHITE wire to the control unit RED

wire.

2. If the parking lights are negative (-) trigger, connect the RED/WHITE wire

to control unit BLACK wire.

3. Connect the RED/BLACK wire to the vehicle parking light wire.

Interior Light Trigger/Illumination

The system’s door trigger will accept a positive or negative door trigger input.

When the alarm is remotely disarmed, the interior lights will turn on for 30

seconds or until the ignition key is turned on. The WHITE/BLACK interior light

supply wire serves two purposes. It informs the alarm whether the door trigger

polarity is positive or negative switching and provides a positive or negative

supply for interior light illumination.

1. Connect the alarm WHITE wire to the vehicle door trigger wire(s).

2. If the door trigger is negative switching, connect the alarm WHITE/BLACK

wire to ground.

3. If the door trigger wire is positive switching, connect the alarm

WHITE/BLACK wire to a constant fused +12 volt source.

Starter Disable

Make sure the YELLOW relay wires are solidly connected. The starter circuit

may draw very high current. We recommend that all connections be soldered.

1. Locate the ignition switch wireloom under the dashboard.

2. Use a voltmeter to find the one wire that will show +12 volts while the

ignition key is in the “CRANKING” cycle only. This should be the starter

solenoid wire.

3. Cut the starter solenoid wire. Test by trying to crank the starter with the

ignition key. If it will not crank, you have the correct wire.

4. Connect one YELLOW wire to the key side.

5. Connect the other YELLOW wire to the starter side.

AMX78(3) Installation Manual - Revised 0799

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Keine Kommentare

AMX AMX78 Installationshandbuch Seite 9