AMX APEX Destiny 6100 Spezifikationen Seite 13
- Seite / 84
- Inhaltsverzeichnis
- LESEZEICHEN
Bewertet. / 5. Basierend auf Kundenbewertungen
13
Wiring Notes
Grounding: In UL installations where the Speaker Supervision option is enabled, grounding is not
permitted.
If grounding, it is recommended a system common be attached to a cold water pipe,
16ga. at 15 feet. Although cold water pipes have been the standard for earth ground,
it is very common in modern construction that a cold water pipe does not provide an
adequate ground due to the extensive use of PVC and other styles of "plastic" tubing.
The best method for grounding the panel is to locate the panel in an area with easy
access to the power company's earth ground.
Telephone Operation: In the event of telephone operational problems, disconnect the control panel by
removing the plug from the RJ31X (CA38A in Canada) wall jack. We recommend
that you demonstrate disconnecting the phones on installation of the system. Do not
disconnect the phone connection inside the control panel. Doing so will result in loss
of your phone lines. If the regular phone works correctly after the control panel has
been disconnected from the phone lines, the control panel has a problem and should
be returned for repair. If upon disconnection of the control panel, there is still a
problem on the line, notify the telephone company and request prompt repair service.
The user may not under any circumstance (in or out of warranty) attempt any service
or repairs to the system. It must be returned to the factory for all repairs.
Communicator: Connection of the fire alarm signal to a fire alarm headquarters or a central station
shall be permitted only with the permission of the local authority having jurisdiction.
The burglary alarm signal shall not be connected to a police emergency number.
Codes: This equipment should be installed in accordance with National Fire Protection
Association's Standard 72 Chapter 2 (National Fire Protection Association, Battery
March Park, Quincy, MA 02269). Printed information describing proper installation,
operation, testing, maintenance, evacuation planning and repair service is to be
provided with this equipment.
Compliance: This device complies with part 15 of FCC rules. Operation is subject to the following
two conditions: (1) It may not cause harmful interference. (2) It must accept any
interference that may cause undesired operation.
Complies with Part 68 of the FCC rules for direct telephone interconnect.
FCC Registration Number: 107USA-74224-AL-T
Ringer Equivalence: 0.8
Use USOC RJ-31X telephone connection jack. Complies with ANSI/UL 1023
Household Burglary Alarm System Units and ANSI/UL 985 Household Fire Warning
System Units.
Connections: Use UL Listed Cable for all connections.
Testing: Weekly testing is required to ensure proper operation of this system
Servicing: To prevent the risk of shock, disconnect telephone line at telephone company supply
jack before servicing this unit.
Battery: Battery normally need not be replaced for at least 3 years. Use a 12 volt 7Ah battery
(minimum). For all UL installations use two 12 volt 7Ah batteries wired in parallel.
- DESTINY 6100 1
- Software Revisions 4
- Table of Contents 5
- System Options and Times 6
- Central Station Features 6
- User Codes 7
- Control Channels 7
- Specifications 8
- Inserting the Cabinet Lock 11
- Mounting the Control Board 11
- To House 12
- From Phone 12
- Wiring Notes 13
- System Terminals 14
- X-10 Interface Cord 16
- Program Mode 18
- Locations and Values 18
- Automated Locations 18
- Exiting Program Mode 18
- Programming 18
- Quick Start 19
- System Input Overview 20
- Programming System Inputs 20
- System Setup Example 21
- Using This Manual: 22
- Program a Zone 23
- Zone Questions 23
- * Zone Type 24
- Zone Options 1 24
- Zone Options 2 24
- Hardware Device Types 25
- Predefined Zone Assignments 25
- Hardwire Inputs 26
- 5816 (MN) 5817 27
- Button Type Devices 28
- Button Functions 29
- Editing Zone Programming 30
- Deleting a Zone 30
- Smoke Verification 33
- Speaker (Bell) Supervision 34
- RF Jam Detection 34
- System Options - Group 1 36
- System Options - Group 2 36
- System Options - Group 3 36
- System Options - Group 4 37
- System Options - Group 5 37
- System Options - Group 6 37
- System Access Codes 37
- System Times 38
- Monitor Trouble Conditions 38
- Bypass Options 38
- Phone Access Options 39
- Event Memory Log 39
- Communicator Times 46
- Two-Way Voice Options 46
- Two-Way Digit Assignments 47
- Report Codes 49
- Dialer Options 51
- Communicator Diagnostics 51
- User Communicator Test 51
- Central Station Terms 52
- Key Function Values 56
- Keypad Option 56
- Keypad Functions 57
- TS16 Group 1 57
- TS16 Group 2 57
- Keypad Area Assignment 57
- User Code + Digit Functions 58
- Extended Monitor Times 58
- Vocabulary 59
- Keypad Function Terms 61
- User Code Options 65
- Disappearing Code Activations 65
- Assigning User Codes to Areas 65
- User Code Terms 66
- Automation Overview 67
- Automation Example 67
- Channel Activations 68
- Control Channel Options 1 69
- Control Channel Options 2 69
- Control Channel Options 3 69
- Control Channel Options 4 69
- Control Channel Locations 70
- System Triggers 71
- X-10 Options 71
- Output Control Assignments 72
- Chain Group Assignments 73
- Control Channel Terms 74
- ADEMCO LIMITED WARRANTY 84
Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme AMX APEX Destiny 6100
(18 Seiten)© 2020, manymanuals.de. Alle Rechte vorbehalten. | 0.035 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern