AMX D-1000 Spezifikationen PDF herunterladen (Seite 25)

Installation

MXD/T-1000 10.1" Modero X Series® Touch Panels

4. Thread the incoming Ethernet and Micro-USB wiring (if Micro-USB access is desired) from their terminal

locations through the surface opening (FIG. 18 ). Leave enough slack in the wiring to accommodate any re-

positioning of the panel.

5. Remove the back box knockouts (FIG. 18) and thread the incoming wiring through the knockout holes.To facilitate

installation, thread the Ethernet cable through a bottom knockout (Landscape) or a right-side knockout (Portrait),

and the Micro-USB or USB cables through a top knockout (Landscape) or left knockout (Portrait)

6. Thread the incoming Ethernet, USB, and Micro-USB wiring (if USB or Micro-USB access is desired) from the

surface opening and through the knockouts.

7. Push the back box into the mounting surface. Insure that the locking tabs lie flush against the back box and that the

back box goes freely into the opening.

8. Extend the locking tabs on the sides of the back box by tightening the screws inside the box until snug. Not all of

the tabs must be extended to lock the back box in place, but extending a minimum of the top and bottom tabs is

highly recommended. Apply enough pressure to the screw head to keep the box flush with the wall: this ensures that

the locking tabs will tighten up against the inside of the wall.

The back box is clear to allow visual confirmation that the tabs have been extended and are gripping the wall, as

well as in assisting with removal if necessary.

9. For additional strength, #4 mounting screws (not included) may be secured through circular holes located at the left

and right sides of the MXD-1000 (FIG. 18). In order to prevent damage to the touch panel, make sure that these are

flush with the back box.

10. Insert each connector into its corresponding location along the back of the device (FIG. 19). To reach the RJ45

connector, gently pull it from beneath the electronics cover (FIG. 20). Attach the Ethernet cable and gently push the

connection back under the cover.

FIG. 18 MXD-1000 Back Box Installation (Portrait)

Knockouts

Back Box

Mounting Surface

Locking

Tabs

#4 Screws

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 41 42

Keine Kommentare

AMX D-1000 Spezifikationen Seite 25