AMX MAX-HT12T Bedienerhandbuch PDF herunterladen (Seite 25)

MXT/D-1000 - 10.1" X Series Panels

MXD/T-1000, MXD/T-700 and MXD-430 Modero X Series® Touch Panels

4. Remove the Backbox knockouts (FIG. 19) and thread the incoming wiring through the knockout holes.

To facilitate installation, thread the Ethernet cable through a bottom knockout (Landscape) or a right-side knockout

(Portrait), and the Micro-USB or USB cables through a top knockout (Landscape) or left knockout (Portrait)

5. Thread the incoming Ethernet, USB, and Micro-USB wiring (if USB or Micro-USB access is desired) from the

surface opening and through the knockouts.

6. Push the Backbox into the mounting surface.

Ensure that the locking tabs lie flush against the Backbox and that the Backbox goes freely into the opening.

7. Extend the locking tabs on the sides of the Backbox by tightening the screws inside the box until snug.

Not all of the tabs must be extended to lock the Backbox in place, but extending a minimum of the top and

bottom tabs is highly recommended.

Apply enough pressure to the screw head to keep the box flush with the wall: this ensures that the locking tabs

will tighten up against the inside of the wall.

FIG. 20 MXD-1000 Backbox Installation (Portrait)

#4 Screws

4X Installation Clamp

for Wall Thickness

.31 [12.0] to .98 [.25.0]

4X Knock-Outs

Remove for Cable

Routing as Needed

The maximum recommended torque to screw in the locking tabs on the plastic

Backbox is 5 IN-LB [56 N-CM]. Applying excessive torque while tightening the tab

screws, such as with powered screwdrivers, can strip out the locking tabs or damage

the plastic Backbox.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 61 62

Keine Kommentare

AMX MAX-HT12T Bedienerhandbuch Seite 25