6
42. Connecting with CSD may cause the ESP to drop 3rd party Ethernet connection (e.g.
AMX/Crestron). 7141 P2
43. The Bypass All button in the Parametric EQ control panel does not work as expected. 7180 P2
44. Saving settings via CC-64 Custom Mode result in PM System Halted Fault (all PowerMatch
amplifier variants). 7248 P2
45. CSD doesn't remove all ESPs with duplicate IP addresses from Project View. 7255 P2
46. PM and ESP mutes assigned to CC-64 via parameter set not updating CC-64 simulator after file
save/reopen. 7047 P3
47. PM Front Panel displays "Firmware Update Complete..." whenever CSD presents the "Firmware
Update failed." Alert. 7128 P3
48. Ethernet disconnect may occur during an upload after the netlist is sent to some devices
successfully, ControlSpace Designer can fail to disconnect correctly in this case. 7154 P3
49. The Power up State / Restore Last Settings PowerMatch property is not enabled within CSD
properties if connecting via USB following enabling it via Ethernet. 7165 P3
50. Copy/paste of CCxx with programming breaks control rules, unlocks adding multiple
groups/inputs/outputs to CC control. 7188 P3
51. Redraw/Repaint issue when dragging the Firmware Update window on WinXP only.7193 P3
52. Unhandled Exceptions and Various issues with groups within CCxx within Dynamic Reassignment
Parameter Sets can occur if a group/block is deleted. 7203 P3
53. Grouped ESP SP blocks are inaccessible in CC64 Custom Mode. 7204 P3
54. Holding in the CC64 Bank 1 button locks the CC64, rendering the CC64 unusable requiring power
cycle. 7205 P3
55. Sometimes receive incorrect response when querying ArrayEQ/Crossover via serial command
after changing via CSD. 7217 P3
56. Snapshot index on Parametric EQ blocks get reset on open file. 7273 P3
57. The PowerMatch 4 Channel Matrix Mixer properties for the Signal Generator row are not set to
read-only. 7274 P3
58. PM 4 Channel Matrix Mixer properties for Signal Generator are not prevented from being
programmed into Parameter Sets. 7275 P3
59. CSD does not recover if USB connection is broken during a firmware update. 5696 P4
60. PM Grouped master Input "Levels" can be adjusted via serial command SG n,l even though they
are of "Grouping Type " Mute”. 7126 P4
REVISION HISTORY
V3.145 (May, 2012)
New Features
1. Support for PM CobraNet card
This release adds support for the new CobraNet expansion card for the PowerMatch™ PM8500/N
amplifier. This new card type is detected automatically when connecting to hardware with the card fitted
or can be added ‘offline’ via the PM8500/N properties window.
PM CobraNet cards will be supplied pre-configured with the receive bundle set to ‘100’ and the first ESP
CobraNet transmit block added to the project will also default to bundle ‘100’ allowing simple out-of-the
box operation from one ESP-88/00 to one or more PM8500/Ns. For more advanced configurations the
bundle assignment for the PM CobraNet card can be changed using the CobraNet Discovery utility.
Further information available in the updated ‘Using CobraNet with ControlSpace and PowerMatch
products’ tech note.
2. New PM8500/N Status Panels
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern