9
22. The gain parameter of the ESP SpeakerPEQ module was internally limited to +12dB and did not
reach the maximum level of +15dB shown in ControlSpace Designer. This has been resolved (#6916)
23. An issue that meant the alignment delay from the factory preset .seq files was not displayed correctly
in the PM8500/N SpeakerPEQ control panel following a download has been resolved. (#6915)
24. Previously it was possible that changes made to PM8500/N output levels via Parameter Set, Group or
serial command without Designer were not correctly reflected in the limiter module and incorrect gain
reduction may have been applied. This is resolved (#6332-5)
25. An issue whereby grouped PM8500/N limiters would cause output settings to become coupled whilst
online has been resolved. (#6581)
26. Previously Group master and member levels could become out of sync following a download and
save to flash in multiple ESP projects, this no longer occurs. (#6615)
27. When a Group is changed from a PM8500N volume group to an ESP volume group the maximum
level is now correctly reset to +12dB. (#6854)
28. In earlier versions Groups were not removed from Parameter Sets when cleared/deleted resulting in
errors when uploading, this no longer occurs. (#6969)
29. PM8500/N SP modules accessible via the front panel (excluding Array EQ) grouped in Designer will
now maintain that relationship whilst offline. Hence changing the parameter on one group member will
cause other group members to be updated. (#6107)
30. When PM8500/N output Group levels were recalled via Parameter Set offline it was previously
possible for the relationship between master and members to become skewed. This no longer occurs
(#6709)
31. An issue that could cause Group levels or Parameter Set recalls to become out-of-sync between
devices when recalled via Designer has been resolved. (#6819)
32. When a PM8500N is connected via USB the correct network address is now displayed in the update
utilities. (# 6277)
33. The ‘Network Setup’ utility now correctly displays all devices ‘visible’ according to the settings of the
network adaptor rather than only showing those using the project or default network addresses.
(#5510/6633)
34. Levels stored at –inf in a Parameter Set are no longer incorrectly changed to -8dB when the file is
saved and re-opened. (#5041)
35. An issue whereby PEQ high and low pass slope controls were not working correctly has been
resolved. (#6644)
36. Setting the AMM module ‘RMS Avg’ parameter to ‘0’ will prevent the channel from gating correctly and
may lock out other channels if the channel ‘priority’ is engaged. This is now prevented in CS Designer,
however users should manually check older designs. (#5548)
37. Support for system-wide serial commands has now been implemented in the PM8500N which means
Parameter Set and Group commands (SS/GS/SG/GG) issued to any network device will be echoed to all
other devices. Module commands (SA/GA) should still be sent to each PM8500N individually.
(6364/5529)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern