AMX NI-3100 Spezifikationen PDF herunterladen (Seite 114)

Terminal (Program Port/Telnet) Commands

104

NetLinx Integrated Controllers- WebConsole & Programming Guide (FMv3)

Terminal Commands (Cont.)

Command Description

SET ICSP TCP TIMEOUT Sets the timeout period for ICSP and i!-Web Control TCP connections.

Note: The new timeout value is immediately (no reboot required).

Example:

>SET ICSP TCP TIMEOUT

This will set the timeout for TCP connections for both ICSP

and i!-Web Control.When no communication has been detected

for the specified number of seconds, the socket connection is

closed.ICSP and i!-Web Control have built-in timeouts and

reducing the TCP timeout below these will cause undesirable

results. The default value is 45 seconds.

The current ICSP TCP timeout is 45 seconds

Enter new timeout (in seconds):

Once you enter a value and press the ENTER key, you get the

following message:

New timeout value set (in affect immediately).

SET IP <D:P:S> Sets the IP configuration of a specified device.

Enter a Host Name, Type (DHCP or Fixed), IP Address, Subnet Mask,

and Gateway IP Address.

Note: For NetLinx Central Controllers, the "Host Name" can only



consist of alphanumeric characters.

• Enter Y (yes) to approve/store the information into the Master.

• Enter N (no) to cancel the operation.

Note: The Device must be rebooted to enable new settings.

Example:

>SET IP [0:1:0]

--- Enter New Values or just hit Enter to keep current

settings ---

Enter Host Name: MLK_INSTRUCTOR

Enter IP type. Type D for DHCP or S for Static IP and then

Enter: DHCP

Enter Gateway IP: 192.168.21.2

You have entered: Host Name MLK_INSTRUCTOR

Type DHCP

Gateway IP 192.168.21.2

Is this correct? Type Y or N and Enter -> y

Settings written. Device must be rebooted to enable new

settings.

SET LOG COUNT Sets the number of entries allowed in the message log.

Note: The Master must be rebooted to enable new settings.

Example:

>SET LOG COUNT

Current log count = 1000

Enter new log count (between 50-10000):

Once you enter a value and press the ENTER key, you get the 

following message:

Setting log count to

New log count set, reboot the Master for the change to

take affect.

1 2 ... 109 110 111 112 113 114 115 116 117 118 119 ... 159 160

Kommentare zu diesen Handbüchern

Keine Kommentare

AMX NI-3100 Spezifikationen Seite 114

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Gateways / Controller AMX NI-3100