AMX NXT-CA7 Spezifikationen PDF herunterladen (Seite 19)

NXD-700i - Installation

NXD-700i & NXT-CA7 7” Modero Touch Panels

NXD-700i - Installation

Overview

NXD-700i panels are installed into either a pre-wall surface (using a CB-TP7 conduit/wallbox) or a solid

surface (using either solid surface or drywall screws).

Unpacking the Panel

1. Inspect and confirm the contents of the shipment box to verify you have all specified parts.

Refer to the NXD-700i Specifications table on page 2 for a listing of included accessories and other

(optional) AMX equipment.

2. Carefully remove the panel from the shipping box.

3. Carefully peel the protective plastic cover from the LCD.

Installing the No-Button Trim Ring

The NXD-700i panel is shipped from AMX with the default Button Trim Ring already installed. The unit is

also shipped with a a No-Button Trim Ring that provides the option of changing the default configuration of the

NXD Faceplate to that with no-button openings.

In order to install this included No-Button Trim Ring, you must first remove the factory-installed default

Button Trim Ring, the two small buttons, and associated two clear light pipes.

1. The Faceplate is secured to the panel with plastic latches. To remove the Faceplate, simply pull it away

from the panel by gently tugging it outwards until the entire Faceplate comes away from the panel.

2. Turn the Faceplate over to expose the inside surface and view the Trim Ring latches (FIG. 6).

3. In a single motion, press down and then outwards on the three Trim Ring latches located along the top of

the internal surface of the Faceplate to begin removing the Button Trim Ring. Removing the Internal

Faceplate from the panel exposes the pushbuttons and light pipes along the inside of the Internal

Faceplate.

4. Gently tug along the edges of the Button Trim Ring and work your way around the edges to remove it

from the Faceplate (FIG. 6).

If the protective plastic LCD cover is not removed, the panel may not respond

properly to touch points on the LCD or allow proper screen calibration.

FIG. 6 Removing the default Button Trim Ring

Default Button Trim Ring

Trim

(with button openings)

Faceplate (outside surface shown)

NXD-700i Panel/enclosure

Ring

Latches

Button latch

Light Pipe latch

(black)

Button and Light Pipe removal

(showing the internal surface of Faceplate)

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 151 152

Keine Kommentare

AMX NXT-CA7 Spezifikationen Seite 19