AMX NXT-CA7 Spezifikationen PDF herunterladen (Seite 69)

Setup Pages and Descriptions

NXD-700i & NXT-CA7 7” Modero Touch Panels

Calibrate Page

The Calibrate page (FIG. 56) allows you to calibrate the touch panel for maximum sensitivity.

Press and hold the Front Setup Access button for 6 seconds to access the Calibrate page.

Press the crosshairs to calibrate the panel and return to the last active firmware page.

System Settings Page (Cont.)

Master IP/URL: Sets the Master IP or URL of the NetLinx Master.

(ETHERNET Only - disabled when USB is selected)

Master Port Number: Enters the port number used with the NetLinx Master.

• Default value is 1319. (ETHERNET Only - disabled when USB is selected)

Username/Password: If the target Master has been previously secured, enter the alphanumeric string

(into each field) assigned to a pre-configured user profile on the Master.

This profile should have the pre-defined level of access/configuration rights.

USB IP Settings: Sets IP settings through the mini-USB port.

DHCP/Static: Switches between HDHCP and Static connections.

IP Address: The IP address of the device

FIG. 56

Calibrate page

If the calibration was improperly set and the Calibrate page cannot be reached

through the panel’s firmware, this firmware page may be accessed via

G4 Web Control. Navigate to the Protected Setup page and press the Calibrate

button through the VNC window. This action causes the panel to go to the Calibrate

page seen above, where the touch panel may be physically re-calibrated again using

the above procedures.

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 151 152

Keine Kommentare

AMX NXT-CA7 Spezifikationen Seite 69