AMX NXT-CA7 Spezifikationen PDF herunterladen (Seite 44)

Configuring Communication

NXD-700i & NXT-CA7 7” Modero Touch Panels

Step 3: Configure an Ethernet Connection Type

Before beginning:

1. Verify that the panel has been configured to communicate through an Ethernet cable connected from the

panel to a valid Ethernet Hub.

2. Verify that the NetLinx Master is receiving power and is communicating via an Ethernet connection with

the PC running NetLinx Studio.

3. Verify that the green Ethernet LED on the rear Ethernet port on the Master is illuminated, indicating a

proper connection.

4. Verify that the yellow LED on the rear Ethernet port on the Master is blinking, indicating communication

with the device.

5. After the panel powers-up, press and hold the Front Setup Access button for 3 seconds to proceed to the

Setup page.

6. Select Protected Setup > System Settings (located on the lower-left) to open the System Settings page

(FIG. 32).

Master Connection section - Virtual Master communication over Ethernet

Before beginning:

1. Verify that the panel has been configured to communicate through an Ethernet cable connected from the

panel to a valid Ethernet Hub.

2. Launch NetLinx Studio (default location is Start > Programs > AMX Control Disc > NetLinx Studio).

3. Select Settings > Master Communication Settings, from the Main menu to open the Master

Communication Settings dialog (FIG. 27).

When using Ethernet as the selected communication method, the NetLinx Master

must first be set up with either a Static IP or DHCP Address obtained from either

NetLinx Studio or your System Administrator.

Before commencing, verify that the NetLinx Master is using the latest available

version of its firmware.

FIG. 32 System Connection page

Obtained

from

NetLinx

Master

When configuring the panel to communicate with a Virtual Master (on your PC) via

Ethernet, the Master IP/URL field must be configured to match the IP Address of the

PC. Make sure to use the Virtual System value assigned to the Virtual Master within

NetLinx Studio.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 151 152

Keine Kommentare

AMX NXT-CA7 Spezifikationen Seite 44