AMX MET-7 Spezifikationen PDF herunterladen (Seite 17)

Custom Button Installation

Metreau Keypads

Custom Button Installation

Overview

With the exception of the DAS-MET-NUM, all Metreau keypads feature field-replaceable pre-printed buttons.

This section describes removing the original set of buttons and replacing them with custom buttons. FIG. 10

provides an exploded view of the keypad assembly.

Removing Buttons

The easiest way to remove and replace buttons on the Metreau keypads is to place the keypad assembly

(FIG. 10) face-down on a flat level surface, so that the buttons stay in position until you are ready to remove

them.

The Faceplate is attached to the Mounting Plate via four plastic tabs (two on each side of the Faceplate, as

shown in FIG. 10). It is not necessary to remove the plastic faceplate from the Mounting Plate in order to

replace buttons.

FIG. 1 Metreau keypads - Exploded view

Plastic Faceplate

Metal Mounting Plate

Buttons

Circuit board

tabs (2 on each side)

remove screw

Disconnect the power supply and all wiring connections before removing/replacing

buttons on the Metreau keypads.

Before touching the device, discharge the static electricity from your body by touching

a grounded metal object.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 83 84

Keine Kommentare

AMX MET-7 Spezifikationen Seite 17