AMX MET-7 Spezifikationen PDF herunterladen (Seite 34)

Wiring and Connections

Metreau Keypads

Split Zone / Analog Volume Control

In cases of split zones where more than one set of speakers are driven from the same keypad, it is sometimes

desirable to place a volume control in the split zone. FIG. 29 shows the connections to a remote zone, and

“Autoformer” volume control device.

Ensure the impedance setting doesn't fall below 4 Ohms.

If you are installing 2 pairs of speakers in a zone and the speakers are 8 Ohms, it is not necessary to

use an impedance matching autoformer type volume control. A standard stereo volume control will

perform properly. The impedance will be approximately 4 Ohms.

If you are using an impedance matching volume control with 2 pairs of speakers set the impedance

matching to the 2X setting.

FIG. 12 Split Zone / Analog Volume control (Option 2) one keypad

Right

Left

Volume Control

Metreau keypad

Right

Left

LDGR

Zone Output Connector

(on Matrix Controller)

It is not recommended to install more than 2 pair of speakers per zone.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 83 84

Keine Kommentare

AMX MET-7 Spezifikationen Seite 34