AMX RPMLoader Bedienungsanleitung PDF herunterladen (Seite 10)

Configuring the NXB-CCG

RPM Device Configuration Guide - NXB-CCG NetLinx Clear Connect Gateway

1. In the NXB-CCG’s WebConsole Add Devices page, click Add/Remove Devices to enter "add/remove devices

mode" (FIG. 10):

The program will indicate that it is entering "add/remove devices mode" (FIG. 11):

In this mode, the NXB-CCG will wait for a device to be identified.

When "add/remove devices mode" is active, the WebConsole will prompt you to press and hold a button on

the keypad (FIG. 12):

2. To add the keypad, press and hold any one of the buttons for approximately 4 seconds, until the Device Heard

popup appears in the WebConsole (FIG. 13) indicating the type of device that reported itself (in this case a keypad):

3. Enter a unique name for the keypad and click the Add button. This closes the Device Heard popup and returns to

the Add Devices page, still in "add/remove devices mode".

4. Click Done to exit "add/remove devices mode" (FIG. 14):

5. Note that the keypad is now indicated in the Devices list. In the example shown in FIG. 15, the keypad added was

named "Keypad":

FIG. 10 NXB-CCG WebConsole - Add Devices page (Add/Remove Devices button)

FIG. 11 NXB-CCG WebConsole - Entering add/remove devices mode

FIG. 12 NXB-CCG WebConsole - Add/remove devices mode active

The keypad that you wish to activate should have all LEDs blinking slowly (two

seconds on, one seconds off). If the LEDs are not blinking, triple-tap-hold-triple tap

any button to restore it to factory defaults, and then wait a minute until it indicates

activation mode feedback (slow blink)

FIG. 13 NXB-CCG WebConsole - Device Heard popup (Wall Keypad)

FIG. 14 NXB-CCG WebConsole - Exiting "add/remove devices mode"

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 35 36

Keine Kommentare

AMX RPMLoader Bedienungsanleitung Seite 10