AMX RPMLoader Bedienungsanleitung PDF herunterladen (Seite 21)

Programming the NXB-CCG (for Clear Connect Dimmers and Switches)

RPM Device Configuration Guide - NXB-CCG NetLinx Clear Connect Gateway

The Switch Programming table consists of three columns:

5. Click in the Level cell to edit the Level value (FIG. 51):

Note that the default (Switch) Level setting for all buttons is On. Select either On or Off.

6. Repeat steps 1-5 for Buttons 2, 3, 4, 5 and 6 (select and configure "Button 2" under CCT Processor, then repeat for

Buttons 3-6.

Once a Switch setting has been configured for Buttons 1 - 6, the On or Off value specified for each Button can be

activated either via the RPM touch panel or by the Switch.

• Device Name: The name of the device (Switch). The Device Name is read-only.

• Level: This is the switch level setting for this button. By default, Level is set to On.

Click inside this cell to edit the switch level value (On or Off) for Button 1.

• Remove: Click to remove the Switch from this Button.

FIG. 51

Switch Programming table - Editing the Level value

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 35 36

Keine Kommentare

AMX RPMLoader Bedienungsanleitung Seite 21