AMX IRLIB Bedienungsanleitung PDF herunterladen (Seite 11)

KI-1856C Rauland RANGER

Head End—

Installation

Page 11 of 55 (Jun-98)

Installation

Setting the Card Server Card(s) (

)

Note: Discharge

static electricity

from your clothes

or body before

handling the

RANCPU

card.

Touch a metal

surface to ground

yourself or use a

grounding strap.

If you have not already done so, mount the

RANCC16

(s) into the rack.

If it is not already off, remove the front panel of the

RANCC16

by loosening the four

small thumbscrews.

If you have not already done so, remove the

card(s) from the

RANCC16

(s).

If your system has multiple

RANCC16

s, set the

DIP

switches on the

card(s) to the

settings detailed in Table 2 (or verify that the current settings match). As systems can

have multiple

RANCC16

s to support additional controllable resources (beyond 16), it

is critical that each card cage have a unique set of addressable slots. These should start

at 1 and continue sequentially. The table that follows shows how to set up the server

cards to address

RAN232, RANDTMF, RANRELAY8

RANIR

cards with addresses

above 16.

Slide the

card between the upper and lower white guides on the

RANCC16

slot

labeled “

CS”

until it snaps into place.

Now you can load other control cards (

RANIR

RAN232, RANDTMF and RANRELAY8

Secure the front panel of the unit.

Connect the 18-gage red wire to the power supply's (e.g.,

RANPS

12) positive terminal

and the black wire to the negative terminal.

Connect the other ends of the 18-gage wires to the

RANCC16

's “Pwr 12

VDC

Nom”

connector (two-pin plug or two-screw terminal strip) located on the unit's back. Be sure

to connect the red wire to the positive side of the connector and the black wire to the

negative side (see the silk screening on the back of the unit for proper locations).

10.

If there is more than one

RANCC

16, you may daisy-chain the power leads as well as

the

AxL

ink “

GND

,” “

AXP,”

and “

AXM”

connections.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 54 55

Kommentare zu diesen Handbüchern

Keine Kommentare

AMX IRLIB Bedienungsanleitung Seite 11

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Software AMX IRLIB