AMX IRLIB Bedienungsanleitung PDF herunterladen (Seite 26)

KI-1856C Rauland RANGER

Head End—

Installation

Page 26 of 55 (Jun-98)

Note: You may use

any

RANCC

16 (#1)

slot except for 5 and

16, which are

reserved by the

system for

controlling the Video

Matrix Switch and

communicating with

the control system,

respectively.

Slide the

RAN

232 card between the upper and lower white guides on the

RANCC

until it snaps into place.

If you will not be installing additional cards, replace the front panel of the

RANCC

Each

232-controlled device that you are installing has a corresponding cable that

goes with it (see the following table). Connect the stripped ends of the corresponding

cable into the top eight pins of the appropriate

RAN

card's connector. You will fin

these connectors in the package of the

RAN

232. Each connector is labeled with its

corresponding slot number.

Table 16. Resource

232 Card Cable Chart

Resource Cable From To

ranpcsw

2293-1

(supplied with

the

RANPCSW

)

or VW2378

RANCC

16 Slot 16

RANPCSW

Serial Port 1

ranlaser

2292 or

VW2293

RANCC

Predetermined

Resource Slot

Location

RANLASER

Interface Connector

ran[xx]vs[yy] (Video

Matrix Switch)

2374

RANCC

16 Slot 5 Utah Scientific Video Matrix

Switch's rs232 Port

AutoPatch Switch

2395

RANCC

16 Slot 5 Auto Patch's rs232 Port

rantitler

2353

DB-25

ONNECTOR

MIGA

)

RANCC16 Predetermined

Resource Location Slot

ranmenu

2378 RANMENU’S

PC S

ERIAL

ORT

RANCC16 Predetermined

Resource Location Slot

RANIR Infrared Control Card

Many of the devices that are operated through the

RANGER

system are infrared-

controlled. In order to provide a universal operating interface for all media devices, the

RANGER

system emulates these devices' original remote control units with the

RANIR

an infrared control card that fits in the

RANCC

16 Control Card Cage. Each

controlled

device (e.g.,

RANVCR

RANCDI

, and

RANVFLOP

) must have a card associated with it.

Additionally, these cards must be programmed with the appropriate

codes (usually

supplied by Rauland-Borg). The

RANIR

card mounts in the

RANCC

16 Control Card Cage

and requires 12

VDC

at 45

power source.

If you are planning on including

controlled devices that are not supplied by Rauland-Borg and you do not have an

RANIRIS

Infrared Capture Unit, please check with Rauland-Borg prior to installation

about the availability of the proper

codes for the devices you will be using (including

classroom televisions). If these devices are not part of our “library,” you may have to

send the devices to Rauland-Borg for programming.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 54 55

Kommentare zu diesen Handbüchern

Keine Kommentare

AMX IRLIB Bedienungsanleitung Seite 26

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Software AMX IRLIB