AMX IRLIB Bedienungsanleitung PDF herunterladen (Seite 53)

KI-1856C Rauland RANGER

Head End—

Installation

Page 53 of 55 (Jun-98)

Note: You must use

RANCC16

(#1)

slot 16.

Slide the

RAN232

card into slot 16 between the upper and lower white guides on the

RANCC16

until it snaps into place.

If you will not be installing additional cards, replace the front panel of the

RANCC16

Connect the (

2393-1) interface cable to from the

RANPCSW

computer's

Com

2 port

(Serial/Com

2). Connect the other end to the

RANCC16

's “

1”

232 port, which is

located on the left-hand side of the back of the unit.

Connect the (

2379) interface cable's

9 connector to the

RANPCSW

computer's

Com

1 port (Serial/Com

1). Connect the stripped ends of the cable into the top eight

pins of the

RAN

232 card's connector (supplied with the

RAN

232) that is located in slot

16. You will find this connector on the back of

RANCC

16 card cage. Each connector is

labeled with the slot number to which it corresponds.

RANSYNCR Sync Pulse Camera

The

RANSYNCR

is a black-and-white camera which produces a sync pulse that is needed

to keep the

RANGER

system’s video output in sync when no resource is assigned to a

classroom monitor. It mounts on the side of one of the media center equipment racks and

requires a 24

VAC

power supply.

Parts Required

0266 (24

VAC

power supply)

BNC

-to-Phono 75 Ω video cables (refer to drawing

2376)

Associated Equipment

1 Three-conductor wire to interconnect the

0266 to

RANSYNCR

Installation

Connect the three-conductor wire between the

0266 (24

VAC

) and the

RANSYNCR

camera terminals labeled 24

VAC

and

GND

. This will provide the camera with power.

Mount the

RANSYNCR

on the side of the rack.

Connect a BNC-to-BNC cable from the

RANSYNCR

's “Video Out” connector to “Input

0” (or whatever input you have designated as your “null video input” in your

Mediapc.ini file on the Video Matrix Switch. See the

RAN

[

]

[

] section for more

information).

Connect the

0266 to a power strip (e.g.,

RAC

900). The

RANSYCNCR

's red “Power”

LED

should light.

RANMENU Character Generator

VGA to NTSC

RANMENU

uses an

IBM

compatible

to generate and display classroom

menus for

the

RANGER

system. A

running

RANMENU

software interprets live serial data fed

from a

RAN232

Serial Control Card housed in the

RANCC16

Control Card Cage. The

data is formatted and sent to the computer

VGA

video output where it is converted to a

composite

NTSC

signal via a

VGA/NTSC

scan converter. The video output is then

1 2 ... 48 49 50 51 52 53 54 55

Kommentare zu diesen Handbüchern

Keine Kommentare

AMX IRLIB Bedienungsanleitung Seite 53

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Software AMX IRLIB