AMX IRLIB Bedienungsanleitung PDF herunterladen (Seite 38)

KI-1856C Rauland RANGER

Head End—

Installation

Page 38 of 55 (Jun-98)

After a few seconds, the red “Verify” light and “Ready” light should both light. To

verify that the signal has been captured, press the same function button again until the

“Ready” light goes out.

When the

RANIRIS

is ready to send the signal to the

, the “Send” light/button will

come on. Press the “Send” button on the

RANIRIS

to transfer the captured code to the

. The characters will appear on the box verifying that the signal is being sent without

problems. The

IRLIB

program will display a message box indicating that the program

is “Loading the function.” After the function has been properly loaded, the program

will display the message box shown in Figure 18, indicating that the transfer was

successful. Pressing any key will return you to the function list.

Figure 18. Function Loaded Indication

Note: Remember

to do this for every

function on each

remote you wish to

program,

including

numbers.

Repeat the steps as many times as necessary to capture all the functions that

correspond with the template that we have provided.

10.

When you have captured a device's functions, you will need to download its

associated control equipment (

RANIR

RANCL101CP

RANCLASS2

RANCL201CP

, o

RANCLASS1

). See the “

RANIR”

section for more information on using

IRLIB

to send

functions to a control device.

IR Template Maps

The following tables map the function positions for the most commonly used

RANGER

media devices. Remember that each controlled function has a unique

position. If you do not put the functions in the appropriate positions, the

RANGER

remote control will not function correctly with the corresponding device.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 54 55

Kommentare zu diesen Handbüchern

Keine Kommentare

AMX IRLIB Bedienungsanleitung Seite 38

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Software AMX IRLIB