AMX IRLIB Bedienungsanleitung PDF herunterladen (Seite 43)

KI-1856C Rauland RANGER

Head End—

Installation

Page 43 of 55 (Jun-98)

Installation

Note: Discharge

static electricity

from your clothes

or body before

handling the

RANDTMF card.

Touch a metal

surface to ground

yourself or use a

grounding strap.

Note: You may use

any RANCC16 (#1)

slot except for 5

and 16, which are

reserved by the

system for

controlling the

Video Matrix

Switch and

communicating

with control system,

respectively.

If you have not already done so, mount the

RANCC16

into the rack.

If it is not already off, remove the front panel of the

RANCC16

by loosening the four

small thumbscrews.

Slide the

RANDTMF

card between the upper and lower white guides of an open slot

on the

RANCC16

until it snaps into place.

Jumper Notes

a. If the Jumper marked

JP2

is installed between the center pin and “AAON,” the

RANDTMF

will start up in the Auto Answer mode.

b. If the Jumper marked

JP1

is installed between the center pin and “PHONE”

positions, the

RANDTMF

will start up in the Phone mode. If this Jumper is installed

between the center pin and “Leased” position, the

RANDTMF

will start up in the

Leased Line mode.

Snap the eight-pin

DTMF

interface board over the first eight pins into the top of the

corresponding card connector on the back of the

RANCC16

Plug in the appropriate analog telephone line extension cable into the

11 Telco jack

on the

DTMF

interface board.

After setting up and configuring the control cards, secure the front panel

of the

RANCC16

Configuring the Media Center for a

DTMF

Classroom for Systems with no Caller

Intercept Zone Information

Once

DTMF

cards are added to the system, the cards must be added to

RANGER

Media Center's Classroom and Console Database. The card's

RANCC16

slot number

must be entered into the “Panel Ctrl Address” field, and the “Classroom Type”

field must be set to

DTMF

control. For more information, see “System Database

Setup.”

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 54 55

Kommentare zu diesen Handbüchern

Keine Kommentare

AMX IRLIB Bedienungsanleitung Seite 43

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Software AMX IRLIB